• Process DMM with 0 to 24mA output
  
• 50,000 count display
  
• 0.05% DCV basic accuracy
  
• 0 to 750 ACV; max resolution 100uV
  
• 0 to 1,000 DCV; max resolution 0.001mV
  
• 0 to 50MΩ; max resolution 0.01Ω
  
• Audible continuity
  
• AC/DC amps up to10 amps; max resolution 0.01uA
  
• Analog bar graph
  
• Min/Max
  
• Data hold
  
• Power off
  
• Separate fuse and battery compartment
• cULus 61010-1
• CAT II-1000VDC, 750VAC, CATIII-600V
• Limited Life time Warranty

Data Sheet

Instruction Manual

196 Specifications
DC Volts	Maximum Input: 1000V Maximum Resolution: 0.0001mV Accuracy: +/-0.05%
AC Volts	Maximum Input: 1000V Maximum Resolution: .001mV Accuracy: +/-0.4%
DC Amps	Maximum Input: 1A Maximum Resolution: 0.0001mA Accuracy: +/-0.5%
AC Amps	Maximum Input: 1A Maximum Resolution: 0.0001mA Accuracy: +/-0.75%
Resistance (Ohms)	Maximum Input: 50MΩ Maximum Resolution: 0.01Ω Accuracy: +/-0.05%
Frequency	Maximum Input: 500KHz Maximum Resolution: 0.01Hz Accuracy: +/-0.05%
Capacitance	N/A
Inductance	N/A
Temperature (K-Type Thermocouple)	N/A
Continuity	Audible at less than 30Ω
Diode	3V at 1mA maximum output
Duty Cycle	N/A
True RMS Responding	No
Conductance	No
Pulse Width	No
Data Hold	Yes
Min/Max Record	Yes
Time Stamp Logging	No
Relative Mode	Yes
Compare Mode	Yes
RS-232 Output	Yes, Optically Isolated
Process Loop Output	Yes (0 to 24mA)
Sleep Mode / Auto Off	Yes
Protective Boot	Yes (standard)
Display Type	50,000 count backlit LCD with dual sub displays and analog bargraph
Range Selection	Auto / Manual
Operating Temperature	32øF to 113øF (0øC to 40øC)
Storage Temperature	-4øF to 140øF (-20øC to 60øC)
Humidity	80% non-condensing
Size	8.3? x 3.7? x 1.9? (210mm x 95mm x 47mm) without boot 8.7? x 4.3? x 2.6 (220mm x 110mm x 65mm) with boot
Weight	1.3lbs (570g) without boot 1.9lbs (850g) with boot
Battery Type	9V Alkaline (NEDA 1604)
Battery Life	50hrs Typical
OverInput Category	CAT III 600V
Agency Approval	cULus 61010-1, IEC 61010-1
Warranty	Limited Lifetime

196 Applications
Thermocouples in furnaces or gas applications
Heat anticipator current in thermostats
Line voltage
Control circuit voltage
Flame safeguard control current
Heating element resistance (continuity)
Compressor winding resistance
Contactor and relay coil resistance
Continuity of wiring
Motor start and run capacitance
Frequency on controls and line voltages
Record min/max voltage of controls and line voltages
Temperature with optional temperature adapter (A310)
Bar graph to indicate rapid fluctuations in measurements
Voltage of direct drive DC motors
Measure power supply voltage
Match components
Compare readings in circuits and components
Frequency of line and control voltage