0.05% accuracy*, 50,000 count display, CAT IV 600volts, True RMS DMM.

AC/DC volts, AC/DC amps, resistance, audible continuity, diode test, frequency, capacitance, and temperature Plus: db,inductance, conductance, duty cycle, pulse width and time stamp logging.

The Triple Display 194 is an innovative new concept in DMM design. The unique display enables you to view more than one event at a time. This eliminates the hassle of switching back and forth to review minimum, maximum or preset comparative values. The meter is also easy to use and built to last.

The DMM 194 is a hand-held autoranging DMM. The backlit LCD can display three readings at one time. In addition to basic function of AC/DC V, AC/DC A, Ohm, Diode test, continuity, Capacitance, Frequency, there is the adaptor function. The meter also has RS232 output and software for recording information into a PC.

Features

• Large 50,000 count display increases resolution and improves accuracy (1.7" x 2.75", 43mm x 70mm
• Triple Display shows more than one reading simultaneously
• 51 Segment Analog Bar Graph to catch fast AC fluctuations
• Back Light (LED Type) allows viewing in any light condition
• Auto Range automatically selects the best range for the measurement
• Separate battery and fuse compartment for easy replacement
• True RMS needed to accurately measure nonsinusoidal AC voltage and current waveforms found on controls and circuits
• Increased safety with Silicone rubber 1,000V CAT III, 600V CAT IV, 10A test leads (CE & cUL listed)
• Auto Power Off DMM will automatically power down after approximately 15 minutes of inactivity to extend battery life. Disable Auto Power Off: Hold down the REC button and turn the meter on.
• Diode Test displays approximate forward bias voltage
• Continuity and buzzer to check for opens and shorts